Laserlock & PX-W1210 S

[fordcapri]

I've a laserlock protected game.

If I used CloneCd and the plexwriter 12/10/32s as reader:
6 hours and 1% then I have cancel it.
Settings I used :
Reading - All off
Writing - All off.


If I used DDump v1.09 and Frontend:
Settings LASERLOCK and ENABLE EXTRACTION OF FULL INDICES. For reading the image I used the UltraPlex 40 max. Time to read to image file on HD is +- 45 min. VERY FAST !!!
Now comes the problem :
I burn ( Plexwriter 12x/10x/32x S firmware 1.00 , on a plextor CDRW at 10 speed) the image with firebuner 1.06 OR with cdrwin 38d. That works just fine !
When I put the backup in my cdrom device the cd-rom goes nuts. It reads, it stops , ... .
If I select a simple TXT-file on the cd then opens it but there's nothing written in the file.STRANGE ???

I've also tested ddump witch a NON protected games. Settings : Standaard.
This give's the same problem.

Can someone tell me what's wrong ? Which writer or reader shall I used ?

[Fernn]

It could be that there is a problem with the program or the CD is heavely protected.
Try reading it with Blindread,it's very good for all this kind of protections and scratched CD's.
You can find it at :-www.blindread/blindwrite.com
I hope it works for you.

Fernn...........

[quote]fordcapri (17-03-2001 14:59):

LASER LOCK STOPS THE LASER DEAD IN ITS TRACKS
I FOUND THAT IF U USE NERO DRAG AND DROP THE FILES THEN REMOVE THE FILE LASERLOCK THAT SHOULD WORK MATE
IVE DONE IT BEFORE

[fordcapri]

I've done it in 40 mins.

Settings from CLONY :

Reading - Read SubChannel Data from Data Tracks on, Bad sector Scanner on,all other settings off.
Writing - All off.

I've used the UltraPlex 40max as reader !!!!!!!!!!
The plexwriter 12/10/32s was MUCH SLOWER (strange?)
So I've stopped the proces.