#1
|
|||
|
|||
Well this is an easy one about S.Disk2
my burner is capable of burning safedisk 2. my question is...
do i need anything other than raw settings in clone cd to burn a 1:1 copy? i dont need beta blocker if im capable of burning sd2 do i?? just burn using the following settings?? Create a CD-Image using CloneCD with these settings: Set Read Speed to 1x (176 kByte/s) Select Read SubChannel Data from Data Tracks Select Read SubChannel Data from Audio Tracks Select Fast Error Skip Set Read Retry to at least 5 Set Error correction to None UnSelect Don't report bad sectors UnSelect Intelligent Bad Sector Scanner When ready burn the CD-Image a CD-R using CloneCD with these settings: Set Write Speed to any desired speed Select RAW DAO Select Don't Repair SubChannel Data UnSelect Simulate Writing (if available) Select Burn Proof/Just Link (if available) unSelect Perform Laser Power Calibration unSelect Wait until Buffers are full Select Always close last Session P.S do i need to select the subchannel data from audio and data for safedisk 2? |
Sponsored Links |
#2
|
|||
|
|||
you do not need to do nething with subchannel data on safedisc 2. reading raw should be the only thing u have to set for safedisc before versino 2.5. read faster, i actually set read speed to max and test burn to a cd rw to make sure the image is ok. i think thats actually faster than reading @ 4x
__________________
I live in a corn field. However, I have the internet, so STOP LOOKING DOWN ON ME ALREADY. |
Thread Tools | |
Display Modes | |
|
|