yener90 installer stuck at 0%

[Razor12911]

I'm pretty sure that there is an unarc.dll failure.

• Because this happens if an incorrect unarc.dll library is loaded. which you can replace but if the conversion works on other computers then it's not it.
• Unarc.dll or other programs which are involved in unpacking like precomp, srep and isdone maybe unable to start for the following reasons, it can be be detected by an anti-virus which is false.
• precomp requires half of computers cpu performance so make sure that all other programs are closed which are using cpu a lot.
• srep requires at least 512mb memory with tweaking it's decompressing and compression memory so make sure you got enough.
• CI and CIU or any other Inno Setup Advanced installer requires an additional memory of 200mb.

I think having 1GB RAM may be the problem. because Inno Requires about 200megs, and srep requires 512MB and loading operating system is another story.

[sentinelks]

I think I will try a compression uharc, I think it best to outdated systems ..

[HellRazor]

I had the same issue with SCII HotS conversion but the only difference is that, while progress bar seems frozen and "Estimated time" keeps rising up to 90 hours, game slowly (really slowly) gets installed. And it does takes some time to install the game (Like 3-4 hours). I didn't test again after I installed Win8.

It was tested on:
AMD Athlon64 X2 4000+ 2.10Ghz
3GB Ram
GeForce GT440
Windows 7

While on friend's PC, installation went fine (though his hardware is far superior)
Intel i5 3.9GHz
8GB Ram
GeForce GTX680 (I think)
Windows 8