|
That’s a very good site. I thought of a couple things to add after looking at that site. When I adjust the white gear, I fine tune it with a DVD RUNNING in the drive. With the drive cover and tray removed just place in a DVD, pop out the white hub from the drive cover and drop it in the DVD. Also I never adjust below 750 Ohms on V4’s and 850 Ohms on V7’s.
The picture of the white gear shows a laser ribbon under it with quite a bit of wear from sliding against a steel shield edge just under the white gear. Yet another one of Sony’s numerous and mind boggling design flaws! When I see wear on a ribbon like this I cut a strip of packing tape to the same width of the ribbon and cover the ribbon with it for a little extra protection.
|
08-02-2004, 04:32
Threaded Mode