|
Pins 5,6, control the tray when using the EA boot method .If you hold down the reset button for 10sec and release it the tray should open if it doesnt it is a bad chip or bad install. the solder points for pin's 5 and 6 are very small and very close together. Using a magnifying glass look at the two pin's carefully making sure no excess solder is touching anything but the two pins and should in no way be connecting the two points together, it only takes a speck of excess solder to short out the connection, also i tape my wires to the board along with the chip so that when i am reassembling the PS2 they dont get in the way of any of the pressure contacts on the board. If you have a version4 PS2 be sure to select a spot on the board for the chip that has enought clearance so that the metal cover will not pinch or groundout the chip...Good luck cleetus i hope this helps and you get it sorted
|