Matrix Infinity V5 Alt. Power Point
 

I want to use some 18AWG wire on the Matrix Infinity Power point on a V5, but It'd be easier to find an alternate point than the VIA for it. Can I use the 3.3V V5 DMS3 point as it's a lot easier. Thanks a lot... LUFCfan :)

I wouldnt use 18 but 24 AWG should be fine when soldering to the via. What I do is actually bridge the via a chip leg to create a large solder blob then solder the pre-tinned 24awg wire to that. But you could actually get away with just useing 30awg if you wanted. The Infinity is very forgiving in this aspect.

Also if you wanted to use the 3.3v source from the DMS3 diagrams for a V5 this would be fine too.

Cheers Sped, you're a top man ;)

Here is a link to a MI install in a V5.

http://www.norcalmods.com/graphix/v5-infinity.jpg

Fantastic Bud - If I can get it like that one, I'm sure it'll work sweet :D