Ps2 Network Adaptor Patch
 

Hey I recently bought a network adaptor for my ps2,
but I can't freakin use it,
because I have a mod chip in it,
is there a way around this at all?:(

important
 

bump.....this is really important:confused:

switch off your mod !!! do a search m8 helps alot !!!!!

What do you mean switch it off? It's a freakin chip in my ps2.
Can you switch them off or sumthing?

Also that website wasn't very helpfull at all m8, I really neeed help with this, otherwise I have wasted alot of money getting this ****en thing.

1, what website are you on about if its my sig why would it have anything to do wiv what your after ????

2,your mod dependant on which one you have can be switched off but as far as i know some newer games can detect a devise and does not allow you to go online !

3, do a friggin search on this forum , calm down . i would post a link to a thread that would help but you didnt take my first piece of advise so have a look for it .:eek:

argh! There's o possible way of me playing any game online because it fails the dnas test, as for my mod, does that mean id have to open up my ps2 and look for a switch?

no.

what chip do you have ? there should be a certain button on the controller you can hold down on bootup to disable the chip, like START or SELECT.

And please don't tell me youre trying to go online through a backup.

I'm not sure what chip I have. How can I find out? And I shall try the start button thingy. thnks.

You know I have seen people state this from the very beginning of the PS2 scene and every time I see it, it just confuses me. Did you just walk in to some hole in the wall shop and say "chip this" and when you got it back all they said was "here you go"? They didn't tell you what they put in it? You didnt ask? Have you forgotten? Did they not tell you how to use it?

NO your not looking for an internal switch. If its a chip thats worth a crap you will be able to disable it with a reset/eject sequence or by holding certain buttons on your controller from standby.

To play online with your originals you will need to disable the chip

Ok thannks, that helps I guess. But I still need to know which button it is to press.

You seem to think there is a "general" method for this.... well there isnt. If you knew what chip you had we would be able to tell you what to do.

What version is your PS2? When abouts did you have this chip installed? Who installed it?

A lot of low end chip can be disabled by holding reset until you see the "Sony Entertainment" screen appear. But if its lets say a Duo2/SE in a V9-V10 then you will hold reset until the split second before you see the "Sony Entertainment screen". Now if its a high end chip like the ....... oh forget it!Figure out what you have and if you care post what you find here.

Same here Sped, I just dont understand it :)

Well I think it's called a "magic boot 2" something along those lines, and it had instructions that if i wanted to watch a dvd i had to hold reset untill the screen had the ps2 thing on it, would that inface be turning it off?

Ummm the only "magic boot 2" that I know of is the "Swap magic boot 2" which is not a mod chip. I'm not sure about the DVD thing you speak of as most chips will read DVD movies with out the need to disable the chip.... but who knows. Until you know what you have its pretty hard to give a definitive answer.

It might be a old Magic2. To load dvd's and PSX games you had to power on the console by pressing and holding reset for 3 sec then release. To disable it i think you press and hold reset for 5 sec.

Magic2 ... damn the good old days :D

Here is the boot procedures if its a Magic 2....

Magic 2
http://www.modchipstore.com/ps2/files/magic2.jpg

NOTE: This is with the disk assumed in the tray and the tray closed:

Playstation 2 games

•Power up normally from STANDBY with RESET button. A single tap of the reset button is required.

Playstation 1 games & DVD Movies

•Power up from STANDBY with RESET button held until the blue EJECT light comes on.
•Then release RESET and the disk will boot.

NOTE: Turn off the PS2 (to standby) before changing Modes (PS1/PS2/DVD)


NOTE: If I remember correctly you cannot turn of the Magic 2..... I think it was starting with the Magic 3 that the mod could be disabled.....

I think your right BG. Its been a long time since i used this chip.

Yes he is right. I do remember some one making a diagram for a switch that could be hard wired to the magic2 in order to disable it, but what a waist .... just upgrade your chip if your going to do all that.

wher can i get an upgrade? im in australia.

go here

http://cyber-mag.com/station/

Tell him I sent you ;)

Awsome, thanks very much and for every1's help.

Can he do me a chip, coz I'm in aus an all. and which chip do you rccomend.

ok maybe I'm thinking wrong but I equivocated Aust. to be Australia. How about you spell out your country name. The link I posted to is a shop in Australia.

Oh awsome so its an Aust shop that's awsome I am in aust sorry i forgot the T sometimes I forget there is a country called Austria, but I guess that has a t aswell but who cares. Well awsome for the aust shop but which mod do you reccomend?