|
#1
12-05-2004, 11:44
|
||||
|
||||
|
problem??
hi i just installed a Ripper 2 GOLD (PAL V3-V10) in a silver ps2 v9 and the chip will only boot ps1 backups and by disableing the chip Original ps2 disks and dvd movies but not ps2 backups i have checked all my points and all the wires and have the solder bridges on the chip done still nothing any ideas???????
|
|
#2
13-05-2004, 05:31
|
||||
|
||||
|
Could be a bad chip???
|
|
#3
13-05-2004, 18:29
|
||||
|
||||
|
Re-check your points - if PS1 backups work then generally the chip is 100% ok - you only need the power and ground and SCEX and reset points to be correct for the PS1 games
- for PS2 games you need all of them except the scex to be correct. Double check boot method first - then check points. Makes ure your wires are as short as possible and kept flat against the mainboard. power and ground should be thicker wires.
__________________
[size=4][B][color=BLACK]ShadowKnyght[/size][/color] [color=purple]Electronic Engineer[/color][/B] [url=http://www.cyber-mag.com/station/ps2tips.htm][color=darkgreen]Tools, tips & suggestions[/color][/url] [url=http://www.cyber-mag.com/station/laser.html][color=red]Laser adjust & clean guide[/color][/url]
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
