Executer 2 problem [Archive]

PompeyStu

19-12-2002, 15:26

I have recently purchased the Executer 2 modchip and i am having a few problems.
I have soldered all of the relevent wires into the correct points but when i apply the actual executer 2 chip the x-box fails to boot. It makes a strange beeping noise and has no picture. When i remove the executer 2 chip the x-box boots fine.
I have tried the chip with the jumper both on and off and it has the same effect.
Anyone have any ideas?

Quall999

19-12-2002, 16:05

That ussually happens when a point isn't soldered right. Recheck all points, and make sure the ground point is soldered. Also, did that chip come preflashed with bios? I haven't checked it out yet.

L-dubb

20-12-2002, 13:30

Also you should make sure that you have the proper bios on the chip, because some chips need to be flashed before usage.

Need mod chip installs? click here (http://internationalgamingworld.com)

beertje

20-12-2002, 13:33

The Executer 2 Lite is delivered with a BIOS.

lazereyes

31-12-2002, 09:54

this chip comes shipped with two bios and a jumper.
jumper closed xbox version 1
jumper open version 1.1
i made the same mistake when i fitted mine